When adding the tool setter. First we need to understand the hardware part of the tool. The principle of the tool setter is equivalent to the sensor switch. In fact, it is a push-type over-sensing switch. The difference with the sensor switch is. In addition to sensing the signal, he needs to. There is also a need for a process to protect the signal and how to wire the tool. Usually there are five wires for the knife. One is a low voltage positive signal. One is a low voltage negative signal. The root is over, the travel signal, and two are jump signals.

Low voltage positive and negative signals. Can directly correspond to the connection. The focus is on the overtravel signal. And jump signals. The meaning of the overtravel signal. That is when the position reaches the travel position. An alarm will occur on the system. This time you need to write in the system program. Corresponding alarm signal. The jump signal one and the jump signal two. It is necessary to trigger a high-speed jump signal inside the system at the same time. The normally open and normally closed points of this signal can be set by system parameters. The zeroth bit of parameter 6200. Is to control whether the jump signal is valid, 6200, the sixth. Is to choose whether the jump signal is the rising signal or the falling signal, the fourth bit of the 6200. Is the control, in the jump signal, whether to use the high-speed jump signal directly? The parameters that need to be modified are also. The fourth place of 6201. The seventh place of 6201. The zeroth position of 6202. About how to use the tool. You should know the timing of the action of the tool. First, the spindle is attached to the shank and moved to the initial plane position. Then quickly drop to the middle position. From the opposite middle position. At a slower rate, drop to the mid-lower key position. At this time, the tip will slowly touch the surface of the tool. Then, go back to a certain height of the set value. The jump signal is triggered again. Drop to work on the knife. When the second knife action is completed. The spindle will quickly return to the initial plane. At this time, the system will pass, measure twice. Calculated, the difference in length. Compensate the corresponding difference to the tool length compensation.